Cisco WAN Switching Modules

Document ID: 10766

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Configurable Alarm Thresholds
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document discusses the MGX 8220 Inverse Multiplexing for ATM Trunk Module (IMATM) configurable alarm thresholds for the physical layer.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Configurable Alarm Thresholds

You can use the xcnfalm command in order to configure alarm threshholds for the physical layer on the MGX 8220 IMATM.

The default integration periods for all RED/YELLOW ALMs (alarms) are:

• 2.5 seconds from No ALM –> ALM

• 15 seconds from ALM –> No ALM

NetPro Discussion Forums - Featured Conversations

Related Information

• Cisco WAN Switching Solutions
• Guide to New Names and Colors for WAN Switching Products
• Product Information for Cisco WAN Solutions
• Technical Support - Cisco Systems