Setting the Initial Configuration on the Cisco 6100/6130 NI-1 DSLAM

Document ID: 12842

Introduction
Before You Begin
      Conventions
      Prerequisites
      Components Used
Step-by-Step Initial Configuration
      Step-by-Step Instructions
Verify
Troubleshoot
Related Information

Introduction

This document describes how to configure a Cisco 6100/6130 NI-1 Digital Subscriber Line Access Multiplexer (DSLAM) that has no stored or running configuration.

Before You Begin

Conventions

For more information on document conventions, see the Cisco Technical Tips Conventions.

Prerequisites

There are no specific prerequisites for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Step-by-Step Initial Configuration

In this section, you are presented with the information to configure the features described in this document.

Step-by-Step Instructions

Follow the steps below to configure a Cisco 6100/6130 NI-1 DSLAM that has no stored or running configuration

Set up HyperTerminal on your PC
1. Connect a serial cable from the System Controller Module (SCM) to a COM port on your PC.
2. Open a HyperTerminal connection.
3. Configure the COM port with the following settings:
  - Bits per second: 38400
  - Data bits: 8
  - Parity: None
  - Stop Bits: 1
  - Flow control: None
4. Remove the SCM card from the Cisco 6100, and insert it again.
5. Press the Return key. Repeat until you see the Cisco 6100 menu, as shown in the following example:
Select 1. Display Diagnostics Status

If the Flash image status is VALID, select 2. Modify IP Address.
Select 3. Modify Subnet Mask
Select 4. Modify Gateway Address
Select 5. Modify Server Ip Address
Select 6. Save IP Values to EEPROM
Type 0 to exit
At the prompt to reset hardware, type YES
Press the Return key. Repeat until you see the Cisco 6100 menu